W212 Сдох электроустлитель после просадки(P0635)

Davidik24

Новичок
Мужики кто сталкивался...W212 после маслания на севшем АКБ сдох электроустлитель EPH :
P063500 — неисправность гидроусилителя рулевого управления
.Пролил его через Vediamo и он начинает опять работать как часы.Пока не заглушить и не дать постоять.Потом опять эта ошибка и сдыхает. И так по кругу.Может кто даст направление...или уже пациента не спасти.
 
по типсам надо в логе смотреть причину...

Fault code P063500 is stored in the control unit of the electric power steering (ES) together with the sub-fault listed
under "Remedy".
The sub-fault is logged in the control unit log or in the fault freeze frame data in the line
"Root_cause_of_DTC_failure_ID" – see example in attachment (001).

Model 204/207/212
1. P063500 with the following sub-faults:
-> 33 - D401 - SDH driver - RPS sensor data comparison failure
-> 164 - D609 - SDA driver - Star point relay switch-off test
-> 176 - D423 - AAD driver - AAD driver timeout
Perform software update of electric power steering (ES) control unit via "Adaptations".
• Part number of optimized software for steering gears with control unit hardware variant A2129017404 is: A2129022011
The software is available as of Xentry Diagnostics DVD 03/2015 with add-on 4437.
• Part number of optimized software for steering gears with control unit hardware variant A2129016606 is: A2129024311


2. P063500 with the following sub-faults:
-> 108 - SDA driver - Star point relay switch-on test
-> 209 - D508 - MDG driver - Current measurement gain error detection
- Check manufacture date of steering gear -> see two digit year (3) and three digit day (4) in attachment 002:
a. Manufacture date greater than or equal to "12065": Perform software update of electric power steering (ES) control
unit - see step 1
b. Manufacture date less than "12065": Replace steering gear
Note: Make sure that the current software is installed in the new electric power steering.

LI46.35-P-055436
 
Назад
Верх